Vulcan-Hart VCG10H, VCG10F, VCG20H, ML-126836, ML-126837, ML-126838 Dokumentacja Pobierz pdf (Strona 38)

– 38 –

MAINTENANCE

WARNING: THE OVEN AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING

OR SERVICING THE OVEN. THE COOKING COMPARTMENT CONTAINS LIVE STEAM. STAY

CLEAR WHEN OPENING DOOR.

CLEAN CYCLE DELIMING PROCEDURE

• With the Programmable Control, select the Clean Cycle [Program Number

00 and

or Program Number 98 and ]. [ CC ] will display as the

Program Number, [ dSCL ] will display in the Temperature Display. Push

Start Stop. The indicator light in the Start Stop key will light. For Manual

Controls, turn the Selector Switch to dSCL.

1. The Steam Generator will drain, the oven will beep for 5 seconds,

[ 40 ] will display in the Time Display and the indicator light in the Start

Stop key will turn off.

2. When replacement of the filter cartridge is necessary, at least every

6 months or when the filter pressure gauge declines to 20 psig, remove

the old filter cartridge and add contents of package of deliming agent,

provided with the filter cartridge replacement and preventive maintenance

kit, to the bowl of the lower filter housing. Add warm water, stir to dissolve.

Reinstall lower filter housing; hand-tightening the filter housing is sufficient.

3. Press the START button. The door closes and locks, and the control

cannot be interrupted until the Clean Cycle is finished. The oven cannot

be turned off. If a power interruption occurs, the Clean Cycle will resume

after power is restored. No other operations can be performed until the

Clean Cycle is [ DONE ].

The timer will start counting down. The steam generator will fill with water

until the water level controls shut off the fill.

The steam generator will heat and produce steam for 30 minutes. After

30 minutes, the steam generator heat goes off and the tank drains.

The Time Display will show 10 minutes. The timer will not count down.

The Steam Generator will fill and drain two times. The fill time is

programmed for each model.

With the Time Display still showing 10 minutes, the time will now begin to

count down while the Steam Generator heats and generates steam. At

the end of the 10 minute interval, the Steam Generator heat goes off and

the tank drains.

[ DONE ] will display in the Temperature Display indicating that the Clean

Cycle is complete.

NOTE: If an error occurs during the Clean Cycle, [ FAIL ] will display in the

Temperature Display instead of [ DONE ].

Per the instructions in the filter cartridge replacement and preventive

maintenance kit: Retest the water, return the response card and replace

the filter cartridge.

1 2 ... 33 34 35 36 37 38 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Vulcan-Hart VCG10H, VCG10F, VCG20H, ML-126836, ML-126837, ML-126838 Dokumentacja Strona 38

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piekarniki Vulcan-Hart VCG10H, VCG10F, VCG20H, ML-126836, ML-126837, ML-126838