Vulcan-Hart 1ER85D Dokumentacja Pobierz pdf (Strona 8)

ERBD, ERBDF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS

VULCAN-HART F-32959 Rev. B (November 2008)

-8-

For 480 volt fryers a separate cord and NEMA 15-5P plug is required (not supplied with

the fryer). Plug in the wire connection into an approved outlet.

Place fryer as near to its final position as possible. Connect 3 phase line to X, Y and Z on

terminal block. To reach terminal block, remove electric cover plate from fryer.

For each 15½” (39 cm) and 21” (53 cm) section, a 3 phase supply line capable of handling

the required KW at the fryer’s rated voltage (208, 240, and 480) is needed. Refer to the

fryer data plate for this electrical information.

LEVELING THE FRYER

Check the level of the fryer by placing a level on top of the fryer after electrical

connections have been made.

Ensure that the fryer is level front-to-back and side-to-side in the final installed position.

If using casters, lock the wheels after unit is level.

OPERATION

Hot oil and parts can cause burns. Use care when operating,

cleaning and servicing the fryer.

Spilling hot frying compound can cause severe burns. Do not move

fryer without draining all frying compound from the tank.

OVER-TEMPERATURE SHUTDOWN

If the shortening becomes overheated, a high-temperature shutoff device will turn the

heating elements off shutting down the fryer.

If the fryer shuts down due to overheating, do not turn fryer on until the shortening

temperature is below 300°F (149°C).

If an overheating situation persists, contact your local Vulcan-Hart authorized service

office.

BEFORE FIRST USE

Cleaning

New units are wiped down at the factory to remove any visible signs of dirt, oil, grease,

etc. remaining from the manufacturing process.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Brak uwag

Vulcan-Hart 1ER85D Dokumentacja Strona 8